|Subject:||[Amps] AL-82 "Glitch" Protection|
|Date:||Fri, 23 Jan 2004 21:58:53 -0800|
Comparing grid and plate current metering circuits of the SB-220 and AL-82 I
find the AL-82 grounds the negative side of the plate meter. Trying to sort out
how to install the metering glitch diodes is a bit confusing here. Of course
Ameritron's idea of an amplifier schematic doesn't make things any easier to
Can anyone give me some help as to where to physically (electrically that is) put these diodes. I can understand the one across the grid current shunt resistor but I need help with the three in series from -HV to ground.
Is there by chance a schematic of the AL-82 that incorporates all the sub boards in one print?
Thanks in advance.
73, Don, W6OA
_______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps
|<Prev in Thread]||Current Thread||[Next in Thread>|
|Previous by Date:||[Amps] SB-220 transformer question, Paul Erickson|
|Next by Date:||Re: [Amps] SB-1000 - 3-500Z restoration, R . Measures|
|Previous by Thread:||[Amps] SB-220 transformer question, Paul Erickson|
|Next by Thread:||Re: [Amps] AL-82 "Glitch" Protection, R . Measures|
|Indexes:||[Date] [Thread] [Top] [All Lists]|