If Voltage across the filament caused bias/linearity/gain variation
problems, then all amplifiers with AC on their filaments would have hum
on the transmitted signal.
60 Hz on the filament varies very slowly compared to RF...its almost
DC...so DC doesn't hurt...except for hypothetical wearout issues.
jeff, wa1hco
Steven Grant, W4IIV wrote:
thanks for the tip...your correct...wouldnt using DC cause a bias condition that may cause linearity problems?.......steven
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|