Hi All
I have used on some hf amplifier that I homebrewed, the Pi network and l did
not have the problem with adjustment maintaining C1 and C2 fixed at the table
value.
I think to find the resonance with dip meter and moving L contact point , I am
doing right thing . Is it correct?
Now i would like to build the power amplifier using the PL network , I have the
table and formulas but l don' t know the correct procedure of adjustaiment .Is
the same thing like the Pi network adjustment ?
And to find the L2 contact point: Can I read the maximum power output ? Or
are there any other methods?
Many thanks in advance, Luca ik5tsw@virgilio.it
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|