Re: [Amps] chimney material suggestion GI35b

[Will Matney <craxd1@ezwv.com>]

Manuel,

It would work if it doesn't touch the heat fin ring itself. It needs to 
be about 1/4" larger I.D. than the O.D. of the tube. The air temp is not 
that hot, but the max temp of the fins is hot enough to melt the PVC. 
I'm working with a company now to supply flame-proof fiber tubing for 
this. I ordered a few samples but haven't tried it yet. I ordered some 
just large enough for a 4CX250B.

Will Matney

Manuel R. Alonso / KC4MNE wrote:

> Hello
>
> Could PVC pipe be used for a chimney? If not were could I find a suitable
> material?
>
> 4" is perfect for the GI35b tube?
>
> Thanks
>
> KC4MNE
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> __________ NOD32 1.880 (20040928) Information __________
>
> This message was checked by NOD32 antivirus system.
> http://www.nod32.com
>
>
>
>  

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps