Pete,
Not necessarily. Heathkit had switches made with different contact
numbers, etc, and the way they switched. To replace them with a standard
can be done, but you have to determine how to re-wire the stock switch
and make it work. You could end up with more poles just to do the same
function the way Heath had it. I think the ones used in the Ameritron
amps were all stock switches.
Will Matney
Pete Smith wrote:
Does this also follow for the meter switch on the SB-220? My rel pwr
and HV functions have stopped indicating, and as far as I can tell the
switch is the only thing these functions have in common. Grid current
continues to read more or less normally.
73, Pete N4ZR
At 10:28 AM 10/31/2004, you wrote:
Jim,
Those switches, from about every manufacturer, are designed around
EIA standards and should fit from one to another. There's several of
these in the Allied catalog, and I think Mouser carries them too.
Will Matney
Jim Monahan wrote:
Reflectees:
Does anyone know of an available replacement for the 4PDT PCB
mounted rotary tap
switch for the meter function HV/IP/PO/ALC.
The circuit designation is SW201A/SW201B.
Thanks in advance.
Please reply directly.
73, Jim, K1PX
K1PX@msn.com<mailto:K1PX@msn.com<about:blank>>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
__________ NOD32 1.880 (20040928) Information __________
This message was checked by NOD32 antivirus system.
http://www.nod32.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
__________ NOD32 1.880 (20040928) Information __________
This message was checked by NOD32 antivirus system.
http://www.nod32.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|