Tomas: Contact Ameritron on this. I do believe they can help with mods to run
the amp on mars freqs.
Am not sure, but maybe you can "mod kit" it up to newer AL-80b specs.
73
Gary
WA6FGI
snip
----- Original Message -----
From: Vic Rosenthal
To: NW7US, Tomas
Cc: amps@contesting.com
Sent: Wednesday, December 01, 2004 9:22 AM
Subject: Re: [Amps] Question: Ameritron AL-80A tuning
NW7US, Tomas wrote:
> Hi,
>
> I am using an AL-80A and have need as an Army MARS and National Guard
> Net member to utilize frequencies far out of normal Amateur Radio
> allocations. I am finding it hard to get the Amp to tune on certain
> frequencies "out of band" - I can get about 100 watts on those problem
> frequencies.
>
> I suspect that the filter netwoks in this Amp prevent it from being
> used too far out of frequency. Is that true?
Check the SWR on your exciter. If the SWR is over 2 or 3 to 1, then possibly
the exciter output is folding back, providing less drive. And this would
indicate that the input pi nets are probably attenuating the drive that does
get
through. So in that case, the answer to your question is 'yes'. I'm not
sure
if it's possible to broaden these input networks, since it would
significantly
reduce the input network Q, causing other problems.
You could retune the 80 or 40 meter input network to reduce the SWR on 5 MHz.
For example if you are an SSB only operator (God forbid) then you could
center
the 80 meter network at 3.9 MHz. or higher. It would still work on the 75
meter
phone band, but the SWR aboove the band would be lowered.
There is also an incorrect Q in the plate circuit. For example, if you are
using the 80 meter position to operate on 5 MHz, the Q would be lower than
normal. This would reduce harmonic suppression, but should actually increase
efficiency slightly. If the plate tuning and loading controls are not at
extremes, then the problem is not related to the plate tank.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|