This applies to grid-driven Class AB1 amplifiers when they are being
neutralized, but not to g-g Class AB2 amplifiers.
On Dec 14, 2004, at 1:16 AM, Steve Thompson wrote:
On Monday 13 December 2004 20:26, Luca wrote:
Hi All
For the Pi or PiL adjustaiment whit the swr analyzer ,it's necessary
to
place a non-inductive resistor egual to the plate impedance,from the
anode
tube and the chassis ground. I would like to know if in the PiL case
,for
the best result, it's necessary to place also the non-inductive
resistor
egual to RM value ,for example 300 ohm, from the load variable
capacitor to
the chassis ground.
No. The resistor from the anode to ground is the only one you need.
Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|