Don't know where they're made, but I've used
the TAYLOR 572-B's here in a SB-200 for
a few years and have had no trouble at all.
Have also used them as replacements for others
amplifiers on a few occasions and all have
worked fine, the last set being purchased about
2 1/2 years ago.
Mark WB8JKR
On Tue, 21 Dec 2004 21:08:18 -0800 (PST) Joe Isabella <n3ji@yahoo.com>
writes:
> Okay... There *ARE* issues with 572Bs -- I'm not an expert on those,
> though. I've always had 3-500s. Good luck!!
>
>
> larry williamson <lgwsaw@worldnet.att.net> wrote:
> Sorry I did not say the kind of amp.... It is a AL 572... Only about
> 8 months old. I just tonight installed the new 51 ohm resistor and
> one new tube form ameritron. Only tried about a 10 minute chat on
> 160 and it seemed to be ok. I will run it more over the next few
> days and see what happens. Both times the amp was on standby for
> about 1 hour and it blew when I keyed up within the first 10
> seconds. The bad thing --- I don't have a lot of knowledge of
> electronics, just the basics.
> Thanks
> Larry
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> ---------------------------------
> Do you Yahoo!?
> Yahoo! Mail - Easier than ever with enhanced search. Learn more.
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|