Amps
[Top] [All Lists]

Re: [Amps] GS35B Plate connection suggestions wanted

To: <amps@contesting.com>
Subject: Re: [Amps] GS35B Plate connection suggestions wanted
From: "Steve Thompson" <g8gsq@ic24.net>
Date: Sat, 5 Feb 2005 22:53:35 -0000
List-post: <mailto:amps@contesting.com>
Mark Hill wrote:
> I have a friend that built at 4 x 4CX250B PA for HF.  When it came to
> connect to the valve tops, he drilled a hole in each the anodes and
> used four screws.  Works fine!
I can't see any realistic clamp hurting the anode on a GS35. A self tapper
in between the vanes would probably work fine. I have to admit to using a
200W soldering iron to connect to '250 anodes in the past - the GS35 would
need a blow torch.

Steve



-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.8.5 - Release Date: 03/02/05

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>