Tuning for max P-out with max-drive is more important than looking for
a dip.
On Feb 9, 2005, at 12:39 PM, George KB2Z wrote:
I'm sure I'm not the first to ask. I have searched in the archives and
did not find a solid answer. I apologize up front and am not trying to
waste anyones time. The directions from different manufacturers dont
seem to answer one way.
As I read the loading instructions for gg hf amps, (2x3-500) they
should be fully loaded at full power then the loading increased 5 to
10% to lower the Ig and help stabilize the output. This seems to be
where it gets confusing for me.
1) After increasing the loading 5 to 10%, should the plate be
re-dipped?
2) If drive is reduced from 100 to 50W, should the plate be re-dipped.
Thanks in advance, George KB2Z
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|