By jove I think I have it!
Thanks for all of the replies.
73, George KB2Z
At 03:39 PM 2/9/05 -0500, you wrote:
I'm sure I'm not the first to ask. I have searched in the archives and did
not find a solid answer. I apologize up front and am not trying to waste
anyones time. The directions from different manufacturers dont seem to
answer one way.
As I read the loading instructions for gg hf amps, (2x3-500) they should
be fully loaded at full power then the loading increased 5 to 10% to lower
the Ig and help stabilize the output. This seems to be where it gets
confusing for me.
1) After increasing the loading 5 to 10%, should the plate be re-dipped?
2) If drive is reduced from 100 to 50W, should the plate be re-dipped.
Thanks in advance, George KB2Z
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|