Joe Subich wrote:
>
> Does anyone have a good way to remove enamel (Formvar?) from thin wires?
The usual way it's done with 'modern' enameled wire (possibly not Formvar) is
by
dipping it in molten solder. A solder pot or the nose of a Hakko 808
desoldering tool works well. Lacking these, a blob on a normal soldering iron
works. You touch the end of the wire to the iron to the tip to help transfer
heat, and then you slowly move the blob along the wire toward the toroid.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|