Re: [Amps] Re.: 500w Amplifier With IRF510's - Schematic updated

[Steve Thompson <g8gsq@ic24.net>]

On Friday 08 April 2005 11:10, Peter Frenning [OZ1PIF] wrote:
> I can only support Steve in this, although all I have tested have been
> within 0.1V of each other (from three different batches)

I should have said there's the alternative to measure them instead.

Perhaps they were all from the same wafer run, but packaged at different 
times, or maybe the process control is easier than with rf power fets. The 
differences with rf ones can be very wide.

73, Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps