Dan,
Check some of the earlier handbooks back in the 80's or 70's. They did have a
table in there for frequency and power to wire size. At 30 MHz, you'll need
around 3/16"-1/4" copper tubing for the coil at 1500 watts. As frequency drops,
the size drops.
Best,
Will
*********** REPLY SEPARATOR ***********
On 4/14/05 at 10:22 PM Dan Levin wrote:
>I'm trying to design a coil that will be used in a 1500 watt filter at HF.
>I know that I need to allow for frequency related skin effect that will
>reduce the area of the wire or tubing carrying the current.
>
>First, I check the ARRL Handbook and the Antenna Book. No formula and no
>table showing suggested wire sizes for a given frequency and power level.
>
>Next, I determine that the skin depth at 28 mHz is .0005", and I calculate
>the copper volume that the current is traveling through at one skin depth
>in
>wires and tubes of various sizes. I get results that seem unreasonable -
>using a current density of 2500 amps / square inch I get a current capacity
>for #14 wire at 28 mHz of under .5 amps and for 1/2" tubing of just a
>couple
>of amps. Yes, I realize that the skin depth is one standard deviation, but
>even allowing for that the capacities seem very low.
>
>Can someone point me at either a formula or a table that will tell me or
>allow me to calculate what the current capacity of a wire or tube is at a
>given HF frequency? Or, I suppose to put it differently since the capacity
>is related to the acceptable temperature rise - something that will tell me
>the copper loss in a piece of wire or tubing at a given frequency?
>
>Thanks!
>
> ***dan, K6IF
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|