Are they still making the 3-1000Z? The only place I could think would be in
China and I don't remember seeing them listed at any of the manufacturers
websites. If they don't, one might find it hard to find a replacement.
Best,
Will
*********** REPLY SEPARATOR ***********
On 5/7/05 at 12:15 PM R.Measures wrote:
>No, it good through 6m, but it's a white elephant and it does have an
>extraordinary amount of feed-back C. .
>
>On May 6, 2005, at 5:33 PM, kf4toh@aol.com wrote:
>
>>
>> thinking about a 3-1000z as a base for a home brew 10 thur 160 amp
>> already have the basic start in parts now
>> tube ! scoket ,fil trans 852 bandswitch , vac cap VAC RELAYS
>> " POLE PIG"
>>
>> is this tube going to fall on its face on the higher bands ?
>> is it a low band tube ?
>> some say its got
>>> a history of parasitic oscillation problems, especially 10 and 15
>>> meters
>>
>> FLAME ON GUYS !
>>
>> JOE KF4TOH
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>
>Richard L. Measures, AG6K, 805.386.3734. www.somis.org
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|