Hi dudes
I have a Kenwood TS870S
and do not have a linear but am building one. My question is about the remote
jack on the backof the Kenwood ts870s. I am planning to use a 12vdc coaxial
relay to switch antenna around the amplifier. The manual shows this jack on
page 5 having a internal switch using pins 2, 4and 5 and pin 7 which has
source 12vdc at 10 amps.
Can I use the pin 7 output to ground to power the 12vdc relay ?
john kb9tc
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|