| To: | amps@contesting.com (Amps) |
|---|---|
| Subject: | [Amps] Bend allowance |
| From: | N7KA@comcast.net |
| Date: | Thu, 04 Aug 2005 03:17:38 +0000 |
| List-post: | <mailto:amps@contesting.com> |
Someone asked about bend allowance for sheet metal. If needed contact me off line as I have info needed to do calcs from work. We de do a LOT of sheet metal fab work and forming is ongoing continuous process for us (mostly aluminum up to .25 inch). 73 de Arne N7KA _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Amps] Chassis construction question 2, Will Matney |
|---|---|
| Next by Date: | Re: [Amps] RE : Another metalwork question, Bill Aycock |
| Previous by Thread: | [Amps] Drake L-4B FS, Keith Dutson |
| Next by Thread: | Re: [Amps] Bend allowance, Ian White G/GM3SEK |
| Indexes: | [Date] [Thread] [Top] [All Lists] |