Hi Neal
Have you checked your mains voltage?
If the capacitors are bad, get the ones from
Harbach - www.harbachelectronics.com
73 de Osten SM5DQC sm5dqc@areteadsl.se
----- Original Message -----
From: "Neal Sacon" <neal@sacon.net>
To: <amps@contesting.com>
Sent: Saturday, August 20, 2005 9:06 AM
Subject: Re: [Amps] caps SB200
>
> While we're on the subject, sort of ...
>
> I've got a PV at idle of about 2100 and it drops to 1600 or 1700 under load.
> I understand it s/b abt 2500. It's the original xformer, but the caps were
> replaced by a prior owner with I'm not sure what, and if the xformer is ok
> (why wouldn't it be?) then is it possible that the exisiting caps are a bad
> replacement and a better replacement would get PV to where it should be ?
> What else could be sucking PV down?
>
> Note also that I don't think it's the metering resistors - output calibrates
> well on an outboard wattmeter.
>
> 73 Neal N7RX
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|