Team,
I've acquired an older Henry 2K-4, which only has one High Voltage setting ~
3500V no load.
It runs a pair of 3-500z triodes and will be driven with ~100W
My question concerns running the amp at reduced output on CW and if it is
better to:
1. Apply full drive, and adjust C1 and C2 until the desired level of output is
achieved...
or as some have suggested:
2. Apply full drive, adjust C1 and C2 until maximum power is achieved, then
reduce the exciter drive without readjusting C1 or C2.
What is the ramification of starting out with reduced drive, (like 25 or 50
Watts) and adjusting C1 and C2 until maximum output is achieved?
Less harmonic attenuation? Some other undesirable effect?
I'm curious because I've heard both approaches suggested and wonder what the
benefit or deleterious effect might be of one method vs. the other.
Your thoughts...
Steve (WG7K)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|