Dear Larry,
You need to be careful about using auto type spark plug wires for HV
cables.
Some are made with graphite cores. These are resistive types and they are
not
meant to carry any significant current.
Matter-of-fact, they might IGNITE if used in an amplifier application,
much like the electrodes in an arc-welder!
Other types of auto spark plug cable use stainless-steel stranded cores.
These have silicone insulation. Still, they are not meant to convey
any significant current.
The best cheap solution is to use HV wire that has double insulation
like what is used for neon sign applications.
Economy Electronics, (http://www.economyelectronics.com) carries
a wide variety of HV wire. I purchased some broadcast transmitter
type wire at a reasonable cost that has 40KV insulation and a 12AWG
tinned copper stranded core with a braided cloth exterior to protect
the HV insulation, but there are other brands and ratings available.
Hal Mandel
W4HBM
On Wed, 26 Oct 2005 09:55:15 -0500 "Larry Carman" <lncarman@swbell.net>
writes:
>
>
> -----Original Message-----
> From: Larry Carman [mailto:lncarman@swbell.net]
> Sent: Wednesday, October 26, 2005 8:44 AM
> To: R.Measures
> Subject: RE: [Amps] High Voltage cable - fitting into SHV type
> plugs
>
>
> I noticed that on some of the old Henry plasma units they used
> automobile
> spark plug wire for HV wire. Not sure if the resistive type plug
> wires would
> be more of a benefit or not to help suppress spikes.
>
> Larry N5BIP
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|