On Sunday, February 26, 2006 9:51 AM [GMT+1=CET],
Bert Almemo <balmemo@sympatico.ca> wrote:
> Would you like to count the number of connector pins on the back of
> your Icom, and convert that into square yardage of phono jacks? Space
> them nicely apart for Swedish-American fingers :-)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
I'd be glad to count them. Here they are for the IC-756PRO III:
ACC 1 pins:
RTTY RTTY keying signal
SEND Keys external amplifier
MOD Modulator input for data modes
AF Audio line output
SQLS Squelch output
13.8v Supplies 13.8v when radio is on
ALC ALC input from amplifier
ACC2 pins:
8v Regulated 8v output
BAND Band voltage output
TRV Activates transverter
I have omitted some duplicate (parallel) pins shared by both connectors.
That is ten jacks. Arrange them in two rows of five, spaced about 1/2 inch
apart and they will fit in an area slightly larger than a typical business
card.
Small enough? There is plenty of room on the rear panel if you would want
them further apart or in a single row.
The "square yardage" you requested is about .0035 :-)
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|