Amps
[Top] [All Lists]

Re: [Amps] CHASSIS

To: N7KA@comcast.net
Subject: Re: [Amps] CHASSIS
From: R@contesting.com;Measures <r@somis.org>
Date: Thu, 16 Mar 2006 00:52:27 -0800
List-post: <mailto:amps@contesting.com>
On Mar 15, 2006, at 5:47 PM, N7KA@comcast.net wrote:

> Nothing wrong with wood box for power supply, been using them since 
> 1960s. HOWEVER, I do make them look nice, walnut stained birch plywood 
> (3/4 thick). Width wide enough for standard 19 inch rack panels, 
> rollers on bottom.  Set the amp on top of box and enclosed back of box 
> also, used G-10 glass board to mount HV connector, and holes in rear 
> cover for air circulation (fan helpful if screened).  Wood is good 
> insulator. Make HV supplies "cat proof."  Helps save marriages.
>
Amen, Arne, and plywood is stiffer pound for pound than metal.  During 
WW-2, the most common beach landing craft were made of mahogany 
plywood.   These craft were designed and manufactured by Andrew Higgins 
in New Orleans, Louisiana.  Higgins' boats were used in both Europe and 
the Pacific theatres.

> Another idea, get surplus rack (open frame fine) and apply walnut 
> stained plywood to sides (your choice of what type of wood).  Latest 
> project used OAK instead of birch veneer plywood.  Sure looks nice and 
> might get XYL approval.  Another PLUS, easier to get and make than a 
> metal chassis.
>
> 73 de Arne N7KA
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>



Rich Measures, 805.386.3734, AG6K, www.somis.org

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>