On Apr 2, 2006, at 3:35 AM, Steve Thompson wrote:
>
>
> R; Measures wrote:
>>
>> On Apr 2, 2006, at 1:18 AM, Steve Thompson wrote:
>>
>>>
>>>
>>> Dan Hearn wrote:
>>>
>>>> I am trying to identify the resistor value and type used in the
>>>> TL922A
>>>> parasitic suppressors. I believe it is a 2W ohmite carbon but not
>>>> sure and
>>>> don't know the value. The schematic in the instruction manual does
>>>> not give
>>>> the value. I am aware of the problems of using carbon resistors in
>>>> this
>>>> application and the use of resistance wire suppressors with metal
>>>> film
>>>> resistors.
>>>
>>> The one I have appears to be 2x47R in parallel.
>>
>>
>> What is the measured R on yours, Steve?
> 24.9 ohms. It's the one you sent me to characterise.
Thanks. That one was virtually unused.
>
> Steve
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Rich Measures, 805.386.3734, AG6K, www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|