In a message dated 04/02/06 19:29:36 Eastern Standard Time, rich@n7tr.com
writes:
So here is the question....This looks like Phenolic type basalite board
(Brown). Anyone used something newer or recommend what I can use to
replace the stock board with? I have a drill press, so no issues
re-drilling a new board. Or if there are boards already built for 8
Screw-in Caps....better yet.
Thanks...
Rich
Rich N7TR
ex KI3V, N3AMK, WB3JOV
www.n7tr.com
Hi Rich
Nice call..... ;-))
I just did a board for my NCL2000. I used some 3/16 XX black bakelite that
I used to provide to Antique Radio Supply in Tempe AZ.
I used the prong-type 105*C radial cans; in series/parallel. I drilled and
chamfered the holes, then installed 1/4" grommets, and peened them in place
with a nail set. [The only way I could configure them to fit in the doubler
housing in the rig.]
The caps click in. The shunts wedge nicely. Solder gives you a very nice
seal and fill.
Got some extra if ya need it. Lemme know if ya need a pix.
Unca Billy
N3TR
_n3tr@arrl.net_ (mailto:n3tr@arrl.net)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|