Amps
[Top] [All Lists]

Re: [Amps] replacement filter caps

To: alan.kaul@att.net (alan.kaul@att.net)
Subject: Re: [Amps] replacement filter caps
From: R@contesting.com;Measures <r@somis.org>
Date: Sun, 9 Apr 2006 13:18:25 -0700
List-post: <mailto:amps@contesting.com>
On Apr 9, 2006, at 12:27 PM, alan.kaul@att.net wrote:

> I recently bought some replacement filter caps  for my Clipperton L.  
> It has been a very long time since I've purchased CAPS, and these 
> particular ones have some kind of mounting prongs --- four in all, 
> with three spaced about 1/4 inch apart in an arc at one side of the 
> base, and another one directly opposite the center ptong.  I found no 
> mention of sockets for these, nor a template ((if I wanted to replace 
> the old didoe/filter board and drill all new holes)).
>
> Anyone have suggestions for mounting these?

Apply 4 buttons of silicone-rubber to flat end, position on insulating 
board and allow si-rubber 24-hrs to cure.  Wire caps with hookup wire.  
A 3w, 100k MOF resistor can be used to bleed each cap and equalize V.
cheers
>
> --
> Alan Kaul W6RCL LaCanada, CA 91011
> e-mail:  w6rcl@amsat.org
> http://
> home.att.net/~alan.kaul/index.html
>       
>               
>                       
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>



Rich Measures, 805.386.3734, AG6K, www.somis.org

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>