Amps
[Top] [All Lists]

[Amps] Really silly question

To: amps@contesting.com
Subject: [Amps] Really silly question
From: Peter Chadwick <g3rzp@g3rzp.wanadoo.co.uk>
Reply-to: g3rzp@g3rzp.wanadoo.co.uk
Date: Wed, 28 Jun 2006 15:16:50 +0200 (CEST)
List-post: <mailto:amps@contesting.com>
So I've had this problem appear on the amplifier......
Bear in mind I've had chance to see it, but not chance to dig in to find out 
what's happening, and it's a fault that has appeared after some 19 years, so is 
arguably not a design problem.
Amp is a pair of passive grid, parallel 4-250A, 300 volts regulated on the 
screen, shunt regulated bias, 3700volts on the plate,  with an interlock that 
kills the power when the bias dies.
The input is a 4:1 impedance transmission line xfmr wound on a 2 inch diameter 
iron dust core, with a shunt load consisting of 4 off 50 ohm, non inductive 
wire wound 50 watt metal clad resistors seriesed up to give 200 ohms. I can't 
remember the transformer inductance.
Running into a good 50 ohm load, all is well at 3.5MHz. At 3.75 up to past 4 
MHz, tuning the PA to resonance leads to a peak in PA current, and the bias 
apparently collapsing, leading to the amp tripping off - just as if it was 
oscillating.
As I say, I haven't had chance to dig into it. First thoughts are that maybe 
the the resistors (or one of them, anyway) have gone open, and the input 
transformer is resonating around 3.8MHz with the input capacity of the tubes. 
Interestingly, on 1.8, 7, 10, 14, 18, 21 and 24 MHz, the amp works OK. I 
haven't checked with any detail the gain, which if the resistors had gone open, 
would be expected to go up. Output tuning is big ceramic caps for tuning and 
loading, a variable inductor and a 500pF variable on the output in shunt with a 
set of switched capacitors. The same tuning cap is used across the whole 80m 
band.
And as I'm travelling this week (again!), I can't readily go and look.
Any ideas? And I don't readily accept VHF parasitics........the shunt resistors 
are 25 watt dissipation Carborundum types, solid carbon rods, and as far as I 
know, still at the original value.
73
Peter I3/G3RZP
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>