Amps
[Top] [All Lists]

Re: [Amps] The maximum amount of 811As and 572Bs in parallel

To: "crawfish" <crawfish@surfmore.net>
Subject: Re: [Amps] The maximum amount of 811As and 572Bs in parallel
From: R L Measures <r@somis.org>
Date: Sun, 23 Jul 2006 17:23:15 -0700
List-post: <mailto:amps@contesting.com>
On Jul 23, 2006, at 11:37 AM, crawfish wrote:

> I have an article using 6 of the 811A's in parallel for 160 meters  
> from 73
> Magazine, early 1980's. I would imagine the output capacitance of  
> more than
> 4 would be too much to tune the plate circuit on say, 15 and 10  
> meters.

If the number of tubes doubles, RL is divided by two, the amount of  
Tune-C needed doubles to main the desired Q, so adding more tubes  
only increases the drive and filament requirement.

>                                   Joe W4AAB
> ----- Original Message -----
> From: "Hsu" <Jbenson@sohu.com>
> To: <amps@contesting.com>
> Sent: Sunday, July 23, 2006 6:05 AM
> Subject: [Amps] The maximum amount of 811As and 572Bs in parallel
>
>
>> Hi,
>>    I have seen some schematic diagram of amplifier, I found that the
> amount of 811As and 572Bs no more than four, Coud someone can tell  
> me how
> much  maximum amount of the tubes in parallel?
>>   Thanks!
>>         73! Hsu
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>

R L MEASURES, AG6K. 805-386-3734
r@somis.org



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>