Kees,
Did you mean to say "no RF Drive?"
And NOT say, "No RF Load?"
Hal
W4HBM
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Kees - pa7two
Sent: Tuesday, February 20, 2007 5:20 PM
To: zl2aaa@paradise.net.nz; amps@contesting.com
Subject: [Amps] Prepare GU74B
Hi OM Morrie.
Time for a serious answer:
Connect only the fillament for 6 hours or so and use household blower to
cool the tube. Check with hot and cold fillaments for shorts.
Then connect the tube into the amplifier, raise the anode voltage by 25%
every 4 hours till maximum. NOTE: gassy tubes will flash over!
After that push the PTT but no RF load for 15 minutes, followed by a 15
minutes cool down. Repeat. After that adust the IDLE current.
Play at half power the first 4 hours. After that try full load.
I hope this helps,
73, de Kees - pa7two
In a message dated 2/20/2007 4:22:22 P.M. Eastern Standard Time,
zl2aaa@paradise.net.nz writes: Hi All. What is the best way to prepare a
GU74B which has not been used forwho knows how long for use in a amp.Tnx
Morrie Saute in olive oil and garlic until brown, add salt and pepper to
taste. Smoother with onions and serve with a garnish of parsley.
ENJOY.......Lou<BR><BR><BR>**************************************<BR> Check
out free AOL at http://free.aol.com/thenewaol/index.adp. Most comprehensive
set of free safety and security tools, millions of free high-quality videos
from across the web, free AOL Mail and much more.
_________________________________________________________________
Find a local pizza place, movie theater, and more..then map the best route!
http://maps.live.com/?icid=wlmtag1
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|