Harbor Freight has the hand tool and the pressnuts.
Has anyone tried them?
73, Harry, W3IIT
----- Original Message -----
From: "Barrie Smith" <barrie@centric.net>
To: <amps@contesting.com>; "Pete Smith" <n4zr@contesting.com>
Sent: Tuesday, April 10, 2007 5:12 PM
Subject: Re: [Amps] RE : amp hardware
> Another option is a device I use at times (can't remember the name at the
> moment. It's at home and I'm at work.) is a largish pair of pliers that
> presses a special nut into a certain hole size.
>
> Captive nut?
>
> Anyway, the pliers aren't really pliers, but are designed to sort of rivet
> these special nuts intp an exact sized hole; the hole size depending upon
> the size of the nut.
>
> It also presses in standoff-type nuts, which are hand for mounting a panel
> or board somewhat above the main chassis.
>
> When I first obtained this device I experimented with it to see how strong
> the system was. In a vice, and using large pliers, I bent 1/8' aluminum
> well before I was able to pull the nut free.
>
> 73, Barrie, W7ALW
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.446 / Virus Database: 269.0.0/754 - Release Date: 4/9/2007
> 10:59 PM
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|