Amps
[Top] [All Lists]

Re: [Amps] (no subject)

To: "k7rdx" <k7rdx@charter.net>, <w2cqm@juno.com>,<amps@contesting.com>
Subject: Re: [Amps] (no subject)
From: "k7rdx" <k7rdx@charter.net>
Date: Wed, 22 Aug 2007 10:34:26 -0700
List-post: <mailto:amps@contesting.com>
The tubes and chimneys have been sold,thanks everyone,Jim..
----- Original Message ----- 
From: "k7rdx" <k7rdx@charter.net>
To: <w2cqm@juno.com>; <amps@contesting.com>
Sent: Monday, August 20, 2007 7:02 PM
Subject: Re: [Amps] (no subject)


> Atta boy scrawny Rawney!Now yer cookin with gas!
> FS:Henry 2K parts removed from working deck: Complete tank circuit
includes
> primary tank,secondary tank (Pi -L) bandswitch with positions 10-80
> meters/seperate position for 75 meters,plate tune air variable,antenna
> loading air variable,coupling caps,plate choke and parasitic
> supressors,everything needed for building a pair of 3-400z or
> 3-500z,etc..125.00 shipped lower 48. Pair of used tested Eimac 3-400z
> tubes,very clean no film or burn marks 175.00 shipped. Pair of sk-410
clean
> sockets used 50.00 shipped. Pair of new sk-406 chimneys,very nice 55.00
> shipped. Misc parts as removed from early 2k please inquire off
> list...Jim,K7RDX..509-884-9307
> ----- Original Message ----- 
> From: <w2cqm@juno.com>
> To: <amps@contesting.com>
> Sent: Monday, August 20, 2007 6:28 PM
> Subject: [Amps] (no subject)
>
>
> >
> >
> > Hi Lou, I just missed you on IM this evening. I spent some time on the
> Drake L4B. I removed the OEM power rocker switch and sold it on QTH
almost
> immediately  for $65 shipped. I replaced it with a switch I had and
> completely rewired the unit with the new 110VAC plug and fuse  bringing
that
> voltage into the rig.  Fortunately, the RF deck components are dual
voltage
> so I was able to make the changeover without too much trouble.  Works FB.
On
> power up, all the components come on in the deck including the fan, neons,
> and the filament/ accessory voltages. Simultaneously,  I send 110VAC down
on
> a interconnecting  power line that activates the remote 115VAC  step start
> power supply controls. The remote power supply has its own 220VAC plug.
> After rewiring the bias, it shouldn't take too long to see if it was
> worthwhile. Ron
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
>

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>