I'm not sure how to respond to my first thread. Sorry if this is a duplicate.
I have been trying to find the cause of my amplifier's output power falling
off. Last night I checked it by transmitting a 400 watt CW signal into dummy
load. After 1 minute output dropped by about 50 watts. At higher wattages the
loss is more pronounced, at 600 watts it may drop to 400 over a minute time.
Now when I apply drive the filament voltage INCREASES. It always used to
decrease under load. That might be a clue, I don't know.
Thanks for all the help on this.
wj2w Jordan
_________________________________________________________________
Connect to the next generation of MSN Messenger?
http://imagine-msn.com/messenger/launch80/default.aspx?locale=en-us&source=wlmailtagline
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|