I would certainly like to see you post a review and picture with
dimensions and weight, etc for that amp on eham reviews.
Probably 95% of us have never seen one or even a picture of one.
thanks
chas/k5dam
Donald Fox wrote:
> Gentlemen:
>
> Thanks for the prompt replies. This is indeed the A model by B&W , and I
> knew that the tubes were good going in because they came from my parts bin.
>
> I agree that the issue with 10, 15, and 20 would seem to be input/output
> circuit related since it appears that 20m drive power is not reaching the
> tubes (no change in plate current) when drive is applied.
>
> 10 and 15 though will draw all kinds of plate current, so drive is getting
> to the tubes, just can't seem to get out. We know the antenna relay works ok
> (for TX anyway), since it works for the lower bands.
>
> The plate meter issue does seem to be mechanical.The needle sweeps across,
> then jolts to a stop. The meter lights are not visible like the SB-220/221. I
> hate to think I would have to remove and disassemble the meters just for
> bulbs.
>
> I would rate the whole amp as a 6-7 in appearance as some of the case
> screws are not oem, and there are small paint scratches and a few other
> cosmetic issues.
>
> I do not know the past owner. I purchased it as a fixer upper from fellow
> ham who did not want to take on the project.
>
> Don n8ech
>
>
>
>
>
>
> ---------------------------------
> Check out the hottest 2008 models today at Yahoo! Autos.
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|