Amps
[Top] [All Lists]

Re: [Amps] 3-500Z filament voltage and current

Subject: Re: [Amps] 3-500Z filament voltage and current
From: Larry <larry@w7iuv.com>
Date: Fri, 11 Apr 2008 08:06:13 -0700
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Quite a few off-list comments were received, so rather than reply to 
each individual, I'll just say thanks to all who responded and summarize.

The consensus on filament voltage was that 4.8 was OK but it would be 
better to have some adjustment available. Most were concerned about the 
drop across the pin/socket interface.

Surprisingly, no one seems to have measured the peak current at the two 
step-start points that are commonly used, (at least with 3-500Z's) so no 
real help there.

Thanks again to everyone who responded.

73, Larry

Larry - W7IUV
DN07dg
http://w7iuv.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>