Don't I recall hearing as a kid that Henry Radio cleaned Collins S-Lines by
putting them in a bath tub and taking the hose to them? I guess it would
depend on how the amp is built and what it will withstand in the way of
water and pressure. Certainly with caution and high quality components, I
would think this could be an option. I imagine it would be important to dry
it quickly with some amount of heat and/or forced air.
I would not hesitate to do this to some of the boat anchors in my barn. But
not others :)
Mark, N5OT
----- Original Message -----
From: "Harold Mandel" <hmandel@barantelecom.com>
To: "Jack/W6NF" <vhfplus@bmg50.com>; "amps" <amps@contesting.com>
Sent: Saturday, May 31, 2008 8:50 AM
Subject: Re: [Amps] How to safely clean an amplifier?
> Jack,
>
> You know in your heart the only true method
> is a total refurbishment: Yank every single
> component out and reduce the unit to a bare
> metal chassis and have it re-plated with
> Iridium Class-III (conductive yellow).
>
> Is this your only amp? Did you buy it just to
> get a signal on the air or for a tinkering project?
>
> Cheap and dirty involves setting it on a milk
> crate in your driveway, removing however much
> as you can, and using cans of tuner cleaner,
> an air compressor and a stiff parts brush,
> blow the crud out, wipe the metal and paint
> down with Windex, let her dry up and
> slam it back together.
>
> Hal
> W4HBM
>
>
>
> {snip}
> I would like suggestions for a suitable cleaner to
> safely remove any deposits of dirt/crud that require
> more aggressive cleaning.
> {snip}
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|