Amps
[Top] [All Lists]

Re: [Amps] SB-220 Drive Levels

To: amps@hidden-valley.com
Subject: Re: [Amps] SB-220 Drive Levels
From: Robert Morris <robrk@nidhog.net>
Date: Thu, 22 Jan 2009 18:24:03 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Jeff Carter wrote:
> Can anyone tell me how much drive the SB-220 needs to make 1.5KW?
> 
> I've seen several references that 100W isn't enough drive for this
> amp.  How much would it take?
> 
> Jeff/KD4RBG
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 
The SB220 was never designed to "make" 1500 watts. It was designed for 1000 
watts INPUT (plate volts x plate current). At 60% efficiency, look for 600 out.

Just because it has 3-500's, the tank coil and power supply were never meant 
for 
more than 600 out.

Because of the usual low plate voltage(2200-2400) trying to drive harder will 
cause extra high grid current and blow the tubes.


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>