Id suggest measuring the voltage at the socket first.
If its below 12.9V RMS then get a higher amperage 12.6V transformer
which wont be loaded down as much; you only need .3V more to be within
the low spec.
Carl
KM1H
----- Original Message -----
From: "George Cortez Jr" <ne2i@optonline.net>
To: <amps@contesting.com>
Sent: Sunday, February 08, 2009 6:20 PM
Subject: [Amps] filament on 3cpx800
>I see the filament voltage is 13.5 volts at 1.5 amps. My alpha
> conversion uses a 12.6volts on the filaments.
> Can I gain efficiency and more power going closer to the required
> voltage? Am I hurting anything?
> How would I go about getting the proper voltage
> George NE2I
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|