hi amp builders,
This is definitely much more of a challenge than I first thought it was going
to be.
http ://home.comcast.net/~kg7hf/PIC_0336. JPG
http ://home.comcast.net/~kg7hf/PIC_0337. JPG
The mosfets used in the h-bridge are supposed to be mounted to a heat sink.
I'm not sure how big of a heat sink it should be. The pictures above show a
possible layout, but I need more room for a filament transformer and a
transformer to provide power to the switching power supply (that is almost
ironic, you need a regular linear transformer to provide bias for the smps .)
At any rate the two black heat sinks in the top right 5.5" long by 3.5" tall x
0.75" fins. The silver heat sink which looks like a Pentium processor is
mounted to the primary bridge rectifier. I
I would like to be able to mount all 4 mosfets from the h-bridge to one of
those heat sinks and push it all the way over to the outside (top right) frame,
then move the hv transformer, the round binocular cores to where the other is,
next to the rf deck.
I'm still playing around with layout, but does anyone have any suggestions?
How about leaving the heat sinks off and mounting directly to the side frame?
Thanks,
Paul, kg7hf
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|