Amps
[Top] [All Lists]

Re: [Amps] Grounded Grid (Screen) 4CX250B power gain

To: "'robert briggs'" <vk3zl@bigpond.com>, <amps@contesting.com>
Subject: Re: [Amps] Grounded Grid (Screen) 4CX250B power gain
From: "Gary Schafer" <garyschafer@comcast.net>
Date: Tue, 21 Jul 2009 21:40:46 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Bill Orr specifically says in his notes that the "supper cathode driven
mode" is NOT recommended for the 4CX250 family of tubes.

73
Gary  K4FMX

> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
> Behalf Of robert briggs
> Sent: Tuesday, July 21, 2009 1:42 AM
> To: amps@contesting.com
> Subject: [Amps] Grounded Grid (Screen) 4CX250B power gain
> 
> I have built 4 amplifiers using the 4CX-250B-350R tubes in the so called
> "Super Cathode Driven" mode, tying the control grid to the cathode and
> grounding the screen grid....This design was in some old Bill Orr notes
> but I am now unable to find the reference, however I think this has been
> covered in this reflector some years back..
> 
> Off the top of my head I remember the idle current for two tubes is
> around 30ma..I used 2500 volts on the anodes and with about 120 watts of
> drive I could get around 650-750 watts output....Not a lot if you
> consider feed through power...I also remember the tuned Pi input circuit
> had to be spot on to get maximum efficiency from the amplifiers..One
> other thing was when fully loaded the Grid current (Screen) was only 2-
> 3ma..
> I don't remember the input circuit parameters but it was fairly
> critical...
> 
> You know while typing this it brings back quite a lot of memories..
> 
> The amplifiers were very stable and reliable and as far as I know are
> all still in use today...Considering that the 4CX250/350 tube pulls are
> a dime a dozen it is still a cheap amplifier and the tubes seem to last
> forever...
> 
> For sockets I used 9 pin loctal types or similar and made up a mounting
> plate with a good air flow around the sockets through the tube
> anodes...I coupled the cathode and grid pins all together using thin
> copper strap...
> 
> These days I prefer to play with the readily available Russian triodes
> also very cheap tough and reliable and I wouldn't bother with the 250B
> type tubes again but at the time when that was all I had to play with
> they were good solid workers..
> 
> 73.
> Bob VK3ZL..
> 
> 
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>