The capacitor across the points was used as part of the ignition system.
You grounded the low side of the primary of the coil with the points, the
current was limited by a
ballast resistance which later was built into the coil and when the points
opened the energy stored
in the primary inductance went to charging up the capacitor and then you had a
damped resonant
circuit. Current oscillated thru the coil and the condenser. It was never
about protecting the points.
In fact, if you removed the condenser you would get a very weak spark.
73
Bill wa4lav
________________________________________
From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf Of
Angel Vilaseca [avilaseca@bluewin.ch]
Sent: Wednesday, February 17, 2010 3:09 AM
To: K1SG@aol.com
Cc: amps@contesting.com
Subject: Re: [Amps] HV Fuses
Just another idea...
In the old car ignitions there was a capacitor in parallel between the
points. This was made to avoid an arc between the points when the point
were switching off 12 Volts into the coil primary.
What we are trying to avoid in an HV fuse is also an arc when the
circuit breaks (wnen the fuse melts).
So how about using an HV capacitor in parallel with the fuse? would that
keep an arc from appearing?
Anyone tried this?
Angel Vilaseca HB9SLV
K1SG@aol.com a écrit :
> In recent threads, there have been a number of comments about high voltage
> fuses.
> Carl mentioned sand-filled fuses, something I hadn't heard of.
> I checked the Mouser catalog for HV fuses, and was stricken with
> sticker-shock...$38 for a fuse?
> OK, we re-think this one...
> I know that an old but workable approach is to use a thin piece of wire
> as a fuse...mount it between a couple of standoff insulators, and it should
> function fine, and if current is substantially too high, the fuse wire
> blows. How do you figure the appropriate size wire to use? And then, how do
> you
> go about ordering 6" of #30 wire, or whatever it is? If you need more
> current capacity, to use the above example, can I put two strands of #30 wire
> in parallel, and expect them to function as a reliable fuse? I'm always
> worried about kinking the wire, or if it's enameled, sanding off more than
> just the insulation.
> The plan is to fuse the HV output of a 5KV 2A supply to a 3X3, which of
> course will only be used at the legal limit or into a dummy load.
>
> Steve Gilbert
> K1SG
> K1SG@AOL.com
> 508-435-9133
> FN42fe
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|