Dick,
The text mentions 950V @ 0.750 per secondary (uses the word each). So it
seems to me that the guy is saying that means, series connected secondaries
should yield 1980V RMS @ 0.75A based on the 240V feed - about same as you
are seeing.
A friend and I were discussing this for use as a possible supply and I
thought it would run about 2600-2700V DC loaded with a FWBR. Just about
perfect also for a set of GI7b. :)
Wonder what the temp rise would be with that TX at the 750 ma draw
sustained???
Not sure if it's the same company or not - but Antek is a huge supplier of
computer power supplies in the aftermarket. Generally speaking a good
reliable name from the PC side of the business.
73/jeff/ac0c
--------------------------------------------------
From: "Dick Hanson" <dick@dkhanson.com>
Sent: Thursday, April 22, 2010 1:23 PM
To: <amps@contesting.com>
Subject: [Amps] HV toroid, ebay item # 370270095930
> Howdy....
> A week or so ago, someone posted that the above units were being sold on
> eBay.
> So, liking HV goodies, I checked it out.
> Looked good, so ordered one.
> It arrived today and pleased to say, seems a very good value.
> With 240VAC on the primary, its putting out just a tad over 2KV.
> I'm thinking it will produce a shade over 2800VDC, with just capacitor
> equalizing resistor load after the bridge.
> Should be about perfect for single 3 or 4 CX800 with full load of 5-600ma.
>
> Anyhow, just a FWIW for anyone contemplating a power supply of this ilk.
> 73
> Dick, K5AND
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|