Amps
[Top] [All Lists]

Re: [Amps] 5CX1500A

To: amps@contesting.com
Subject: Re: [Amps] 5CX1500A
From: Roger <sub1@rogerhalstead.com>
Date: Thu, 06 May 2010 15:31:50 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>

On 5/6/2010 2:30 PM, Dieter Horst wrote:
> Bear in mind the heater when you consider building something out of it.
>
> 38.5 Amps @ 5 Volts...
>
>    
It's a really nice tube, but my data sheet shows 5V @ 40A, but instant 
on with a Thoriated Tungsten filament.
It typically runs at a higher plate impedance than most of us are using. 
It's good for full output of 1785 watts to 110 MHz.


I'm interested, but after a couple major purchases I'm a wee bit on the 
strapped for cash side. Prices vary over a wide range on e-bay.

73

Roger (K8RI)

> 73, Dieter DL5RDO
>
>
>
>    
>> A local radio club has one to sell - NOS, boxed, Eimac. It's come
>> from spares stock at a physics research place.
>>      
>    
>> Anyone here interested? Equally, I'd welcome suggestions as to value.
>>      
>    
>> Thanks,
>>      
>    
>> Steve
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>      
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>    
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>