[Top] [All Lists]

Re: [Amps] Amps Digest, Vol 90, Issue 36

Subject: Re: [Amps] Amps Digest, Vol 90, Issue 36
Date: Thu, 1 Jul 2010 02:09:49 EDT
List-post: <">>
Hi Bob,
That was me.  I've been looking for a 1 mA (or less) meter for an amp  
project, with dimensional requirements that it 
1. fit in the circular hole, and 
2. cover the extraneous holes that remain from earlier iterations of  the 
It sounds like the meter you have would probably fill the bill.  Would  it 
be possible to see a picture of the meter? Or better, one each of the front  
and the back, so I can see how the barrel sits on the meter.
That would be very helpful.
Thanks very much!
Steve  Gilbert

In a message dated 6/30/2010 3:00:26 P.M. Eastern Daylight Time, writes:

Message:  7
Date: Wed, 30 Jun 2010 11:23:55 -0700 (PDT)
From: Robert Groh  <>
Subject: Re: [Amps] inquiry for a replacement  panel meter
Message-ID:  <>
Content-Type:  text/plain; charset=us-ascii

A couple of days ago someone posted  looking for a replacement meter for a 
(I assume) already built  amplifier.  At the time, I didn't have anything 
that was close but I was  just cleaning out and organizing and I found one 
which might be close although  I think it is a bit tall.  I trashed the 
original email hence this  one.

My meter is from a early "multi-tester", i.e. I think it combined  a tube 
tester with a voltmeter and ohm-meter. Meter sensitivity unknown  (although I 
could measure it if needed) but I'm reasonably sure it is 1 mA FS  or 
better. It has a rectangular face about 4-5/8" wide x 4-1/8" tall and the  
is 2-3/4" diameter.  Case is black bakelite. 

If anyone is  interested, just give me a shout at <>

Bob  Groh, WA2CKY

Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [Amps] Amps Digest, Vol 90, Issue 36, K1SG <=