Re: [Amps] Can I cool too much the tubes?

["Bill, W6WRT" <dezrat1242@yahoo.com>]

ORIGINAL MESSAGE:

On Wed, 18 Aug 2010 10:34:58 -0700 (PDT), Rudy Bakalov
<r_bakalov@yahoo.com> wrote:

>Experience trumps specs. The amp goes into standby mode after about 30 minutes 
>running at full power, i.e. about 1200 W.  If I run it at around 400-500 W it 
>is fine.

REPLY:

If it were mine, I would measure the tube seal temps when it goes into
standby. It could be that Ten-Tec has been ultra conservative on it's
shutdown point. 

73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps