The GS35B can be a little difficult to handle or remove from the socket.
To overcome this problem, I made up a small T bar from 1/2 inch
copper pipe and on the bottom of it, I silver soldered a hex head
bolt with the same thread as the cooler retainer nut on the GS35B. I
simply screw the bolt into the top of the nut and pull on the handle
and out comes the tube.
73, Alek
VK6APK
http://www.qrz.com/db/vk6apk
http://www.qrz.com/db/vk6ap
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|