Amps
[Top] [All Lists]

Re: [Amps] Plated screws

To: <donroden@hiwaay.net>, <amps@contesting.com>
Subject: Re: [Amps] Plated screws
From: "Carl" <km1h@jeremy.mv.com>
Date: Fri, 19 Nov 2010 15:45:34 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
SS is fine for both chassis and most RF use altho unplated brass is best for 
real power. For general mounting steel rusts and brass tarnishes which looks 
tacky after awhile. I use nickel plated brass for most work since I picked 
up a fair assortment at the National Radio auction in 91. There is an 
industrial fasteners outfit 2 towns away for when I need something special.

Carl
KM1H


----- Original Message ----- 
From: <donroden@hiwaay.net>
To: <amps@contesting.com>
Sent: Friday, November 19, 2010 1:51 AM
Subject: Re: [Amps] Plated screws


> Ace Hardware has brass screws, but I'm not sure why they would have to
> be plated  ( ??? )
>
> Don W4DNR
>
> Quoting Stirling Schmidt <kc0nxm@sbcglobal.net>:
>
>> Hi all:
>> Where's a good place to source nickel-plated brass screws? I have
>> some from ages
>> ago, but I'm assuming the hardware store zinc-steel variety are 
>> inappropriate
>> for amp assembly, as they are magnetic.
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>