Amps
[Top] [All Lists]

Re: [Amps] Tube Cooling..

To: amps@contesting.com
Subject: Re: [Amps] Tube Cooling..
From: Ian White GM3SEK <gm3sek@ifwtech.co.uk>
Reply-to: Ian White GM3SEK <gm3sek@ifwtech.co.uk>
Date: Sat, 27 Nov 2010 23:53:55 +0000
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Carl wrote:
>> So the entire anode cavity fills up with hot air...
>>
>> Collins contributed many excellent ideas to the amplifier gene pool, but
>> that certainly wasn't one of them.
>
>
>Now that is a reply Id expect from those that reply without using much 
>mental effort but not from you Ian. Due to the cavity design and the 
>width of the anode cooler it didnt leave much choice.
>
>The amp certainly does not show signs of overheating either.
>

OK - if it works well enough, then it works.

The point I was trying to make was that there are better ways. Most 
designers recognise that heating of the cavity is a major source of 
tuning drift, especially at UHF, so they choose cavity configurations 
that allow cooling of the tube without heating up the cavity.

If the cavity design didn't allow that in this particular case, it 
suggests that the cavity had been designed first, without much thought 
to cooling, leaving with  the designer of the cooling system with no 
other choices.


-- 

73 from Ian GM3SEK
http://www.ifwtech.co.uk/g3sek
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>