Tests have shown that the turbulance from the high speed Harbach does little
for the cooling unless a shroud is added. The one saving grace is a WW
resistor can be added to reduce the speed a bit and reduce the noise;
150-250 Ohms 20W seems to do well. Dentron and Amp Supply used a resistor in
many of their amps.
Carl
KM1H
----- Original Message -----
From: "David G4FTC" <g4ftc@hotmail.com>
To: <amps@contesting.com>
Sent: Friday, December 17, 2010 1:47 AM
Subject: Re: [Amps] Fan for SB220
>
>
>> A local ham buddy just got back into the hobby after an 8 year hiatus and
>> got a hold of 2 SB220's. He noticed they run hot and he asked the
>> following question...so I figured there are folks out here who might know
>> the answer
>>
>> "....see how guys like the Harbach fan kit for the SB220? Mine is running
>> hot and LOUD. I oiled the
>> bearings and cleaned it off of dust, but it's still got to go"
>>
>> Anyone done this mod?
>>
>> I recommended a small muffin on top to help extract the hot air for now.
>> I did it on my old 30L1 and it sure cooled it down.
>>
>> Thanks
>
>
>
> I'm using one of the Harbach fans on a SB220 - they move a lot more air
> than the original Heathkit fans.
>
> Higher air-flow = higher noise
>
> But I can't say I've noticed that it runs hot.
>
> Regards
>
> David G4FTC
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|