Hi Carl,
I believe bandwidth limitations are for audio transmissions in general, and
not specific to SSB...
More details surely may be found if you snoop around this Industry Canada
(our FCC) website:
http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf01226.html
~73~ de Eddy VE3CUI - VE3XZ
**********************************************
----- Original Message -----
From: "Carl" <km1h@jeremy.mv.com>
To: "Jim Thomson" <jim.thom@telus.net>; <amps@contesting.com>
Sent: Tuesday, March 29, 2011 10:43 AM
Subject: Re: [Amps] Homebrew is back..
>
> ----- Original Message -----
> From: "Jim Thomson" <jim.thom@telus.net>
> To: <amps@contesting.com>
> Sent: Tuesday, March 29, 2011 10:51 AM
> Subject: Re: [Amps] Homebrew is back..
>
>
> >
> >
> > Subject: RE: [Amps] Homebrew is back..
> >
> >> Dang-it guys. Just when I was starting to be satisfied with SSB you had
> >> to
> >> go and make me think about nice, big, plate modulated AM audio again.
> >> That
> >> is going to cost me. It takes me back to many winter nights in a very
> >> warm
> >> room listening to such nice audio and wonderful smell of transmitter.
> >>
> >> Sam, N9FUT
> >
> > &&&& And you can easily get nice sounding audio with 4-6 khz wide
> > ESSB....and still only
> > use one half the BW of an AM signal.
> >
> > later... Jim VE7RF
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> I thought SSB BW was limited in Canada?
> Besides AM can even be copied on a crystal set, that silly ESSB stuff is
> pretty exclusive.
>
> Carl
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|