Amps
[Top] [All Lists]

Re: [Amps] 813 Amplifier Article

To: Rob Atkinson <ranchorobbo@gmail.com>, Carl <km1h@jeremy.mv.com>
Subject: Re: [Amps] 813 Amplifier Article
From: "Fuqua, Bill L" <wlfuqu00@uky.edu>
Date: Fri, 1 Apr 2011 13:28:44 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
I once knew a guy in Nashville, John Brown, who loved building amplifiers in 
the 1960's.
He made a RF deck that he drove with his TR3 or TR4 which he could change 
sockets and
try different tubes that most people would not try or had be advised not to try.
   One setup was four 4-65As in grounded grid. Talk about hot plates when he 
pushed up the plate input power. They were a bright yellow
  Another set up was 4x  4CX250bs or were they 4X150A/7034? No difference 
really.
He tried direct grounded grid, they were toasted.  Then connected the g1 to k 
and low 
power gain but worked well and lastly he tried g1 to ground via a resistor to 
limit grid dissipation.
None worked out to his satisfaction. 
   73
Bill wa4lav

________________________________________
From: Rob Atkinson [ranchorobbo@gmail.com]
Sent: Friday, April 01, 2011 12:45 PM
To: Carl
Cc: Fuqua, Bill L; amps@contesting.com
Subject: Re: [Amps] 813 Amplifier Article

I guess I am mistaken, I somehow got the impression they were hard to
find because I never see them at hamfests or on eBay but I guess I
have looked at the wrong times and places.

73

Rob
K5UJ

On Fri, Apr 1, 2011 at 8:23 AM, Carl <km1h@jeremy.mv.com> wrote:
> Ive never understood the claim that 4-65A/8165's are scarce. The USAF used
> them and NIB surplus seems to be ignored just like the 803, 814, 4E27A and a
> few other tubes.
>
> Henry also used them in the driver stage of a 3CX3000A7 13.560 MHz ISM
> transmitter they private labeled.
>
> Carl
> KM1H
>
> ----- Original Message ----- From: "Fuqua, Bill L" <wlfuqu00@uky.edu>
> To: "Rob Atkinson" <ranchorobbo@gmail.com>; <amps@contesting.com>
> Sent: Thursday, March 31, 2011 11:07 PM
> Subject: Re: [Amps] 813 Amplifier Article
>
>
>> On ebay there are 2 NOS 4-65As at $10 and one day left.
>> And another one BUY NOW for $12
>> I checked completed sales and some went for less than a $ recently.
>> I think you can get them cheap.
>>  EIMAC had a data sheet for the 4-65A that had a spec running them hard
>> at SSB service with more output than a 4-125A but no IMD data.
>> I think this was perhaps for the mobile and portable military rigs like
>> the PRC-47 and
>> others.
>>  73
>> Bill wa4lav
>> ________________________________________
>> From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf
>> Of Rob Atkinson [ranchorobbo@gmail.com]
>> Sent: Thursday, March 31, 2011 10:08 PM
>> To: amps@contesting.com
>> Subject: Re: [Amps] 813 Amplifier Article
>>
>> The Temco RA-150 used the 4-65A.  I don't have that rig so I'm not
>> interested in the tube but anyone owning that rig might not mind
>> picking up a few extras if they don't have them already.
>>
>> A pretty cool rig... http://www.amfone.net/Vintage%20Radio/temco_ra150.htm
>>
>> 73
>>
>> Rob
>> K5UJ
>>
>>
>> <<<
>> Rob, K5UJ wrote...
>>
>>> Glad to hear it.  I had thought 5-125 was almost unobtanium; even
>>> harder to find than 5-500s and 4-65As.
>>
>> I've got two NOS, sealed in their plastic envelopes, 4-65A's.  If anyone
>> is
>> interested,
>> make an offer.
>>
>> 73,
>>
>> George T Daughters, K6GT
>> CU in the California QSO Party (CQP)
>> October 1-2, 2011
>>>>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>