OK
I have removed the bare neutral ground wire from the jack. It makes no
difference considering they paralleled each other the whole length.
I looked at the 41 page article as suggested. Really, 41 pages.
john W9ZY
~~~~~~~~~~~~
On 4/4/2011 8:26 AM, Commander John wrote:
> I twisted the 2 grounds together and installed them in the center pin jack as
> it was that or cut one off.
> Is there a better way?
PLEASE go back and STUDY what I and several others have written several
times in this thread, and in the power and grounding tutorial that's on
my website. http://audiosystemsgroup.com/publish.htm
NEVER, EVER, connect NEUTRAL to GROUND at any point other than the point
where it enters the building. The proper connections to your amplifier
are the two 240V hot wires and the green wire. The neutral must NOT be
connected.
73, Jim K9YC
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|